![]() ![]() Refer to section 3 (procedure 3.3) and activate VistaEasy View (installed as part of VistaEasy). Refer to section 3 (procedure 3.2) and perform Device Setup (installed as part of VistaEasy) to register the device in VistaConfig. See see section 3, VistaEasy installation. Note: VistaEasy must be installed before running the Driver Setup program from the start button. Kodak Dental Imaging Software Installation 6.1 Driver Setup Program Refer to section 3 (procedure 3.1) for initial computerdevice setup and install the VistaEasy application provided on the DBSWIN disk included with each device. ![]() ![]() This allows full device functional operation via the TWAIN interface and the third party imaging management application. Kodak Dental Imaging Software Installation 6.1 Full Device Functional Install the VistaEasy software by selecting it from the DBSWIN setup program menu. Refer to section 1 and make sure that the computer system being used has the requirements necessary to operate ScanX.Ĭheck or set the monitor resolution using the procedure provided by section 2 for the Windows operating system in use.ĭevice Setup Perform the following to setup and configure ScanX to operate as a TWAIN device. Kodak Dental Imaging Software Installation 6.1 Driver Setup Program.Kodak Dental Imaging Software Installation 6.1 Full Device Functional. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |